dali-2 & push dimmable led driver power supply junction box manufacturers 12v 300W

■ Mechanical Specification 

1. Input 3*18AWG,Black cable (L), White cable (N) and Green cable (G).

2. Output 2*16AWG (12V) 2*18AWG (24V, 36V,48V) Black cable (V+) connect to positive(+), Red cable(V-) connect to negative(-).

3. Dimming wire 2*18AWG Purple cable(L), Pink cable (N).

Warm tips:  Any other requests for cable, we can customized.  

※Dimming cable   

※Dimming electronic cable 3*18AWG, Brown DA/N and Purple DA/L (No polar) connected to the DALI BUS when use DALI function.

Brown (N) is connected to AC (N) while Purple (L) and pink connected to Push dim switch dimmer( L) when use Push function.

※Please make sure you connect these correctly otherwise your product will not function correctly and could be damaged.

Note:  there is external antenna at output side.  Don't disassemble!

 ■ Dimming Operation   

※Note: For DALI Dimming Wiring Diagram 3, please noted that only one DALI power is need in the DALI bus, so no extra DALI power is needed if the Master or Dimmer already includes the DALI Power. 

■ DALI-2 address setting Operation 

※The default address for the DALI-2 LED driver is 001.

※Address settings device:

※Address settings:

① RDM setting address:

Set the address by the RDM device. For detailed operation, please refer to RDM device instruction manual.   

② NFC setting address:

The DALI-2 led drivers’ address can be read and written by a mobile with NFC APP or NFC handheld device (NFC read & write device: NFC-RW) by close to the NFC signal area of the DALI-2 LED drivers. 

■ Adjust output voltage Operation

※Adjust output voltage slightly for DALI-2 LED drivers

1) The driver output voltage can be read and written by a mobile with NFC APP or NFC handheld device (NFC read & write device: NFC-RW) by close to the NFC signal area of the DALI-2 LED drivers. 

2) Voltage range: level 1~10, each level is 0.2V. The default output voltage level is 1. 

■ How to set the DALI-2 CV LED driver address by the NFC app or NFC device ?

Simple operation about DALI-2 LED driver address reset and adjusting output voltage slighting by a mobile with NFC APP (set NFC) or NFC handheld device (NFC read & write device: NFC-RW)  

Mobilephone NFC APP setting:

 NFC handheld device setting: 

 ■ Instruction:

 This driver should be installed by qualified and professional person;

 Please make sure the driver is installed with adequate ventilation around it to allow for heat dissipation.

 Ensure that wiring is correct before test in order to avoid light and power supply damage;

 If the dimmable LED drivers do not work normally, pl. don’t maintain privately, but contact us: sales1@smartselectronics.com Or take a phone call: 0086-595-27256889